====== IsegBegin() ======

''IsegBegin()'' sets the CLK/DIO pins and device number of a TM1637 FND display.

{{:en-us_commands:reference:isegbegin.svg?900|IsegBegin command operation flow}}

''bool IsegBegin(uint8_t clkPin, uint8_t dioPin, uint16_t bitDelayUs = 100, uint8_t device = 0)''

===== Commands =====

^ Command ^ Arguments ^ Return Value ^ Operation ^
| ''IsegBegin(clkPin, dioPin, bitDelayUs, device)'' | ''uint8_t clkPin'' — Arduino pin number connected to FND CLK\\ ''uint8_t dioPin'' — Arduino pin number connected to FND DIO\\ ''uint16_t bitDelayUs = 100'' — TM1637 bit communication delay (µs), default ''100''\\ ''uint8_t device = 0'' — FND device number ''0~6'', defaults to ''0'' | ''bool'' | Sets the CLK/DIO pins and device number of a TM1637 FND display. |


===== Example =====

<code cpp>
void setup() {
  IsegBegin(14, 15, 100, 0);  // Set the CLK/DIO pins and device number of the TM1637 FND.
  IsegBegin(130, 131, 100, 1);  // MPAINO K/K2 GPIO channels 0, 1
  IsegBrightness(7, true, 0);  // Set display brightness and on/off state.
  IsegBrightness(4, true, 1);  // Set display brightness and on/off state.
}

void loop() {
  IsegDecimal(1234, false, 0, 4, 0, 0);  // Display an integer in decimal format.
  IsegHex(0xABCD, false, 0, 4, 0, 1);  // Display an integer in hexadecimal format.
}
</code>

===== Precautions =====

  * These commands are only for 4-digit FND displays with a TM1637 IC. They do not directly drive a generic multiplexed FND display.
  * Use display commands after successfully calling ''IsegBegin()''.
  * Initialization fails if CLK and DIO use the same pin, or if the device number is ''7'' or higher.
  * ''length + position'' must be 4 or less. Numbers outside the range are not displayed, and ''false'' is returned.
  * Communication may block execution for several ms. Do not call this from an interrupt service routine.
  * Do not use the specified pins simultaneously for UART, PWM, encoders, external interrupts or other functions.
  * Check the actual module and product manuals for FND power and signal voltages.

===== Built-in Commands in the Same Category =====

  * [[:en-us_commands:reference:isegbrightness|IsegBrightness() View detailed description]]
  * [[:en-us_commands:reference:isegclear|IsegClear() View detailed description]]
  * [[:en-us_commands:reference:isegwrite|IsegWrite() View detailed description]]
  * [[:en-us_commands:reference:isegdecimal|IsegDecimal() View detailed description]]
  * [[:en-us_commands:reference:iseghex|IsegHex() View detailed description]]
  * [[:en-us_commands:reference:isegencodedigit|IsegEncodeDigit() View detailed description]]

[[:en-us_commands:builtin|← Built-in Command List]]