====== IsegEncodeDigit() ======

''IsegEncodeDigit()'' converts one digit to segment data.

{{:en-us_commands:reference:isegencodedigit.svg?900|IsegEncodeDigit command operation flow}}

''uint8_t IsegEncodeDigit(uint8_t digit)''

===== Commands =====

^ Command ^ Arguments ^ Return Value ^ Operation ^
| ''IsegEncodeDigit(digit)'' | ''uint8_t digit'' | ''uint8_t'' | Converts one digit to segment data. |


===== Example =====

<code cpp>
const uint8_t CLK_PIN = 14;
const uint8_t DIO_PIN = 15;

void setup() {
  IsegBegin(CLK_PIN, DIO_PIN, 100, 0);  // Set the CLK/DIO pins and device number of the TM1637 FND.
  IsegBrightness(5, true, 0);  // Set display brightness and on/off state.
}

void loop() {
  const uint16_t value = analogRead(A0);  // Read the raw analog value of the specified channel.
  uint8_t digits[4] = {
    IsegEncodeDigit((value / 1000) % 10),  // Convert one digit to segment data.
    IsegEncodeDigit((value / 100) % 10),  // Convert one digit to segment data.
    IsegEncodeDigit((value / 10) % 10),  // Convert one digit to segment data.
    IsegEncodeDigit(value % 10)  // Convert one digit to segment data.
  };
  IsegWrite(digits, 4, 0, 0);  // Output segment data at the specified position.
  delay(100);
}
</code>

===== Precautions =====

  * These commands are only for 4-digit FND displays with a TM1637 IC. They do not directly drive a generic multiplexed FND display.
  * Use display commands after successfully calling ''IsegBegin()''.
  * Initialization fails if CLK and DIO use the same pin, or if the device number is ''7'' or higher.
  * ''length + position'' must be 4 or less. Numbers outside the range are not displayed, and ''false'' is returned.
  * Communication may block execution for several ms. Do not call this from an interrupt service routine.
  * Do not use the specified pins simultaneously for UART, PWM, encoders, external interrupts or other functions.
  * Check the actual module and product manuals for FND power and signal voltages.

===== Built-in Commands in the Same Category =====

  * [[:en-us_commands:reference:isegbegin|IsegBegin() View detailed description]]
  * [[:en-us_commands:reference:isegbrightness|IsegBrightness() View detailed description]]
  * [[:en-us_commands:reference:isegclear|IsegClear() View detailed description]]
  * [[:en-us_commands:reference:isegwrite|IsegWrite() View detailed description]]
  * [[:en-us_commands:reference:isegdecimal|IsegDecimal() View detailed description]]
  * [[:en-us_commands:reference:iseghex|IsegHex() View detailed description]]

[[:en-us_commands:builtin|← Built-in Command List]]