====== MPA Y Module ======

The Y module adds three analog output channels to an MPA Series controller. Each channel's DIP switch and MP STUDIO function block determine the output range. Y and K modules can provide up to 12 output channels in total.

===== Select the output range =====

^ DIP switch ^ Function block ^ V+ terminal ^ I+ terminal ^
| ON | ''DAC'' | DC 0–5 V | DC 0–10 mA |
| ON | ''DAC2'' | DC 1–5 V | DC 2–10 mA |
| OFF | ''DAC'' | DC 0–10 V | DC 0–20 mA |
| OFF | ''DAC2'' | DC 2–10 V | DC 4–20 mA |

Use ''V+'' for voltage or ''I+'' for current. The negative terminal is connected internally to GND. Match the DIP switch setting to the input type of the connected equipment.

===== Example: set an output value =====

With CH0's DIP switch OFF, ''DAC'' minimum ''0'', maximum ''100'', and output value ''10'', the ''V+'' terminal outputs approximately 1 V. In MP STUDIO, press ''['' to insert ''DAC'', then set the channel and value range.

===== Check before use =====

  * Confirm that the ordered product includes a Y module.
  * Connect voltage inputs to ''V+'' and current inputs to ''I+'' after checking the receiving device's input specification.
  * ''DAC'' and ''DAC2'' have different zero points. For 4–20 mA, use DIP OFF with ''DAC2''.
  * If K modules are also installed, check the combined Y/K channel count.

[[https://www.ilogics.net/en-us/resources/downloads/manual/11|View output terminal and wiring diagrams in the MPA manuals]]

[[en-us_products:mpa|Back to MPA Series]]