Differences

This shows you the differences between two versions of the page.

--- en-us_commands:reference:debugstate [2026/09/07 23:35] – 바깥 편집 127.0.0.1
+++ en-us_commands:reference:debugstate [2026/09/14 20:30] (current) – external edit 127.0.0.1
@@ Line 17: / Line 17: @@
 <code cpp>
 void setup() {
-  debugStart(Serial, 115200, SERIAL_8N1);  // Set the port and baud rate for debug output.
+  debugStart(Serial, 115200, SERIAL_8N1);  // Start the serial port for debug output.
-  debugln(F("diagnostics ready"));  // Output the debug value followed by a newline.
 }
 void loop() {
-  const int32_t input = analogRead(A0);  // Read the raw analog value of the specified channel.
+  if (millis() >= 5000 && debugState()) debugStop();  // Stop debug output after five seconds.
-  if (debugState()) {  // Return whether debug output is enabled.
+  if (debugState()) {  // Check whether debug output is enabled.
-    debug(F("A0="));  // Output values only when debugging is enabled.
+    debugln(millis());  // Print elapsed time while debugging is enabled.
-    debugln(input);  // Output the debug value followed by a newline.
   }
-  if (IdigitalRead(0, 5)) debugStop();  // Read the input repeatedly and update only if all samples match. If HIGH and LOW are mixed, retain the previous stable state. / Stop debug output.
+  delay(500);
-  delay(250);
 }
 </code>
@@ Line 37: / Line 34: @@
   * Rapid repeated output can slow the control cycle and communication responses.
   * Stop unnecessary Debug output before deploying for operation.
+===== Built-in Commands in the Same Category =====
+  * [[:en-us_commands:reference:debugstart|debugStart() View detailed description]]
+  * [[:en-us_commands:reference:debugstop|debugStop() View detailed description]]
+  * [[:en-us_commands:reference:debug|debug() View detailed description]]
+  * [[:en-us_commands:reference:debugln|debugln() View detailed description]]
 [[:en-us_commands:builtin|← Built-in Command List]]