Differences

This shows you the differences between two versions of the page.

--- en-us_commands:reference:itpl [2026/09/07 21:52] – 만듦 - 바깥 편집 127.0.0.1
+++ en-us_commands:reference:itpl [2026/09/14 20:30] (current) – external edit 127.0.0.1
@@ Line 14: / Line 14: @@
 ===== Example =====
+This example selects MPINO-8A4R(T)-S and uses input ''P0'' and output ''P32''. Call the command on every pass through ''loop()'' without blocking it. A rising input turns the output on for 1 s; another rising edge during the pulse restarts the 1 s period.
 <code cpp>
-bool Iton(uint8_t timer_id, bool state, unsigned long delayTime);
+const uint8_t INPUT_PIN = 0;
-bool Itof(uint8_t timer_id, bool state, unsigned long delayTime);
+const uint8_t OUTPUT_PIN = 32;
-bool Itpl(uint8_t timer_id, bool state, unsigned long delayTime);
-bool Itmon(uint8_t timer_id, bool state, unsigned long delayTime);
+void setup() {}
-bool Itmr(uint8_t timer_id, bool state, unsigned long delayTime, bool reset = false);
-unsigned long IgetTime(uint8_t timer_id);
+void loop() {
-bool IgetState(uint8_t timer_id);
+  const bool inputOn = digitalRead(INPUT_PIN) == HIGH;
+  const bool outputOn = Itpl(0, inputOn, 1000);  // Make a 1 s pulse on a rising edge; another edge restarts it.
+  digitalWrite(OUTPUT_PIN, outputOn ? HIGH : LOW);
+}
 </code>
 ===== Precautions =====
-  * Timer interrupt callbacks run inside an ISR. For safety, change only flags in the callback and perform actual control processing in ''loop()''.
+  * Call the timer command repeatedly in ''loop()'' so elapsed time and OFF input are processed.
-  * Do not use slow or interrupt-dependent code such as ''delay()'', ''Serial'', I2C or SPI in callbacks.
+  * Do not share a ''timer_id'' between different timer operations; use a separate ID for each.
-  * Normally, call ''ImodbusRTU()'' repeatedly in ''loop()''. Call it from a timer interrupt with a sufficient interval only when long ''delay()'' calls or debug output slow down ''loop()''.
-  * Do not use the default ''ItimerSet()'' together with ''tone()'' using Timer2 or ''analogWrite()'' on Timer2 PWM pins.
+===== Built-in Commands in the Same Category =====
-  * Explicitly using Timer1, Timer3, Timer4 or Timer5 may conflict with PWM, analog output or high-speed counter functions using that timer.
-  * Configure only one ''Itimer'' callback per hardware timer.
+  * [[:en-us_commands:reference:iton|Iton() View detailed description]]
-  * Defining an ISR for the same timer directly in the sketch may conflict with ''Itimer'' operation.
+  * [[:en-us_commands:reference:itof|Itof() View detailed description]]
-  * ''ItimerStopAll()'' stops only hardware interrupt timers. It does not reset PLC-style timer states such as ''Iton'', ''Itof'' or ''Itmr''.
+  * [[:en-us_commands:reference:itmon|Itmon() View detailed description]]
+  * [[:en-us_commands:reference:itmr|Itmr() View detailed description]]
 [[:en-us_commands:builtin|← Built-in Command List]]