en-us_products:mp_studio:indexed_address

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
en-us_products:mp_studio:indexed_address [2026/11/12 20:37] – external edit 127.0.0.1en-us_products:mp_studio:indexed_address [2026/11/13 13:42] (current) – external edit 127.0.0.1
Line 110: Line 110:
   * **① Out-of-range cell:** ''D0'' is -200, so the address points outside the area before ''D100'' and is shown in red as "Out of range (D0 = -200)". ''MOVE'' is skipped, so ''D200'' keeps its previous value.   * **① Out-of-range cell:** ''D0'' is -200, so the address points outside the area before ''D100'' and is shown in red as "Out of range (D0 = -200)". ''MOVE'' is skipped, so ''D200'' keeps its previous value.
   * **② ''@IXERR'' rung:** ''@IXERR'' is on, so the coil after it is on.   * **② ''@IXERR'' rung:** ''@IXERR'' is on, so the coil after it is on.
-  * **③ Notice:** "An index went out of range — @IXERR is on and that instruction was skipped. (last: row 0)"+  * **③ Notice:** "A value was out of range (such as an index, bit number, or count), so @IXERR turned ON and the instruction was skipped (last: row 0)."
  
 > **@IXERR does not turn off by itself** > **@IXERR does not turn off by itself**
 > ''@IXERR'' stays on even after the index comes back into range. Turn it off with a RESET coil (''@IXERR'') in the ladder, or by writing 0 to it in the Data Table during monitoring or simulation. Unlike the other ''@'' system bits, ''@IXERR'' accepts a written 0. After a download, it starts off. > ''@IXERR'' stays on even after the index comes back into range. Turn it off with a RESET coil (''@IXERR'') in the ladder, or by writing 0 to it in the Data Table during monitoring or simulation. Unlike the other ''@'' system bits, ''@IXERR'' accepts a written 0. After a download, it starts off.
  
-''@IXERR'' also turns on when ''BSFT'', ''BRST'' or ''BSETN'' of the [[:en-us_products:mp_studio:bit_control|bit control functions]] goes outside its area while running, or when one cycle of ''TFLK'' does not fit in its timer (V1.4.0 and later). In a program that does not use indexed addresses, the notice appears only when ''@IXERR'' is on the ladder screen or in the Data Table, so check it with an ''@IXERR'' contact in the ladder.+''@IXERR'' also turns on when the count, bit number or step number of one of the [[:en-us_products:mp_studio:bit_control|bit control functions]] goes out of range while the program runs, or when one cycle of ''TFLK'' does not fit in its timer (V1.4.0 and later; bit numbers and step numbers in V1.5.0 and later). In V1.5.0 and later, the notice also appears in a program that uses only bit control functions, without "(last: row N)".
  
 ===== Input Assistance ===== ===== Input Assistance =====
en-us_products/mp_studio/indexed_address.1794483455.txt.gz · Last modified: by 127.0.0.1

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki