Differences

This shows you the differences between two versions of the page.

--- en-us_products:mpino_studio2:troubleshooting [2026/09/12 21:05] – 만듦 - 바깥 편집 127.0.0.1
+++ en-us_products:mpino_studio2:troubleshooting [2026/09/12 21:18] (current) – external edit 127.0.0.1
@@ Line 17: / Line 17: @@
 | The Serial Monitor shows no values. | Connection, baud rate, sending code | [[#when_the_monitor_is_connected_but_shows_no_values|4. Monitor Values]] |
 | Ladder power flow or values are missing or frozen. | Monitoring port, uploaded settings, connection | [[#when_the_monitor_is_connected_but_shows_no_values|4. Monitor Values]] |
-| Ladder status differs from physical I/O. | Selected board and ladder pin map | [[#when_ladder_status_differs_from_physical_io|5. I/O Results]] |
+| Ladder status differs from physical I/O. | Selected board and ladder pin map | [[#when_ladder_status_differs_from_physical_i_o|5. I/O Results]] |
 | Edits or settings are not reflected. | Required save, apply, build, or upload step | [[#when_settings_or_edits_are_not_reflected|6. Changed Results]] |
@@ Line 30: / Line 30: @@
 | No location in the Problems tab | Read the error in Build Output and the log immediately above it. | [[en-us_products:mpino_studio2:first_project|Phase 1 · Build]] |
-Build again after making a correction. Wait for the build result before diagnosing an upload problem.
+Build again after making a correction. Check the build result before moving on to the upload.
 ===== 3. When the Upload Does Not Start or Stops =====
@@ Line 63: / Line 63: @@
   - Check whether the relevant contacts and coils change their **power-flow indication** during ladder monitoring. If no indication appears, check the monitoring connection first.
   - Confirm that the board selected in the project matches the connected product.
-  - Open **Settings → Ladder Pin Map** and check **Use**, I/O direction, and the physical pin mapping for the P address.
+  - Open **Settings → Ladder Pin Map Settings** and check **Use**, I/O direction, and the physical pin mapping for the P address.
   - Compare the address shown on screen with the actual terminal in the product documentation.