This is an old revision of the document!

IsegBrightness()

IsegBrightness() sets display brightness and visibility.

bool IsegBrightness(uint8_t brightness, bool on = true, uint8_t device = 0)

Commands

Command	Arguments	Return Value	Operation
`IsegBrightness(brightness, on, device)`	`uint8_t brightness` — Brightness `0~7` `bool on = true` — `true`: display ON, `false`: display OFF `uint8_t device = 0` — FND device number `0~6`, defaults to `0`	`bool`	Sets display brightness and visibility.

Example

void setup() {
  IsegBegin(14, 15);       // MPAINO: TXD(D14), RXD(D15)
  IsegBrightness(7);
  IsegClear();
}
 
void loop() {
  IsegDecimal((millis() / 1000UL) % 10000UL, true);
  delay(200);
}

Precautions

These commands are only for 4-digit FND displays with a TM1637 IC. They do not directly drive a generic multiplexed FND display.
Use display commands after successfully calling IsegBegin().
Initialization fails if CLK and DIO use the same pin, or if the device number is 7 or higher.
length + position must be 4 or less. Numbers outside the range are not displayed, and false is returned.
Communication may block execution for several ms. Do not call this from an interrupt service routine.
Do not use the specified pins simultaneously for UART, PWM, encoders, external interrupts or other functions.
Check the actual module and product manuals for FND power and signal voltages.

← Built-in Command List

ILOGICS Product Documentation

Table of Contents

IsegBrightness()

Commands

Example

Precautions