debugStart()

debugStart() sets the port and baud rate for debug output.

void debugStart()
void debugStart(unsigned long baudrate)
void debugStart(HardwareSerial& serialPort)
void debugStart(HardwareSerial& serialPort, unsigned long baudrate, uint8_t config = SERIAL_8N1)

Commands

Command	Arguments	Return Value	Operation
`debugStart()`	None	`void`	Sets the port and baud rate for debug output.

Example

const bool DEBUG_MODE = true;
 
void setup() {
  if (DEBUG_MODE) {
    debugStart(115200);  // Set the port and baud rate for debug output.
  }
}
 
void loop() {
  checkInput();
  checkOutput();
}
 
void checkInput() {
  debug("AI0=");  // Output values only when debugging is enabled.
  debugln(analogRead(A0));  // Read the raw analog value of the specified channel. / Output the debug value followed by a newline.
}
 
void checkOutput() {
  debug("millis=");  // Output values only when debugging is enabled.
  debugln(millis());  // Output the debug value followed by a newline.
}

Precautions

Do not use the same port for Debug and product communication.
Rapid repeated output can slow the control cycle and communication responses.
Stop unnecessary Debug output before deploying for operation.

Built-in Commands in the Same Category

← Built-in Command List

ILOGICS Product Documentation

Table of Contents

debugStart()

Commands

Example

Precautions

Built-in Commands in the Same Category