IanalogRead() converts the analog input value to the specified integer range.

int32_t IanalogRead(uint8_t ch, int32_t min, int32_t max)

void setup() {
  Serial.begin(115200);
}
 
void loop() {
  int32_t percent = IanalogRead(A0, 0, 100);  // Map the analog input value to the specified integer range.
  Serial.println(percent);
  delay(500);
}

• min and max define the conversion range of the return value, not the actual electrical input range of the sensor.
• Range limiting by Iscale() or Iscalef() keeps the result between the two specified output endpoints.
• Setting min greater than max reverses the output range. Example: IanalogRead(A0, 100, 0).
• MPINO and MPAINO have different raw ADC ranges. Always use ch appropriate to the selected board.
• Set the MPAINO analog input module's DIP switches and wiring to match the actual input type.
• This command performs only linear range conversion. Sensor error compensation, open-circuit detection or 4~20mA software Cut requires separate processing.

• IanalogReadf() View detailed description

← Built-in Command List