IanalogWriteInit()

IanalogWriteInit() sets the maximum, minimum and mode of the MPAINO analog output.

void IanalogWriteInit(uint8_t ch, uint32_t maxValue = 65535UL, uint32_t minValue = 0, bool mode = false)

Commands

Command	Arguments	Return Value	Operation
`IanalogWriteInit(ch, maxValue, minValue, mode)`	`uint8_t ch` `uint32_t maxValue = 65535UL` `uint32_t minValue = 0` `bool mode = false`	`void`	Sets the maximum, minimum and mode of the MPAINO analog output.

Example

This example uses MPAINO-8A8R(T) with a Y output module and Analog Output Module → Y selected. It sets CH0 to a 0–1000 range and outputs its midpoint.

void setup() {
  IanalogWriteInit(0, 1000, 0, false);  // Set Y module CH0 to a 0–1000 range.
}
 
void loop() {
  IanalogWrite(0, 0, 1000, 500);  // Output the midpoint of the configured range.
  delay(500);
}

Precautions

Match the module DIP switches, external power supply and output range.
Do not configure these together with PWM functions sharing the same timer.
Do not output values to uninitialized channels.
Currently, MPAINO Y analog output supports channels up to 0~11; do not use 12~15.
analogWriteInit(), analogWriteFreq() and analogWriteMax() are for Y analog output channels and must not be used for high-speed pulse channels 20~31.
Do not use high-speed pulse GPIO numbers 130~141 with analogWrite().

Built-in Commands in the Same Category

← Built-in Command List

ILOGICS Product Documentation

Table of Contents

IanalogWriteInit()

Commands

Example

Precautions

Built-in Commands in the Same Category