IMcMem()

IMcMem() sets the sizes of X, Y, M and D memory used by MC Protocol.

void IMcMem(uint16_t x_size, uint16_t y_size, uint16_t m_size, uint16_t d_size)

Commands

Command	Arguments	Return Value	Operation
`IMcMem(x_size, y_size, m_size, d_size)`	`uint16_t x_size` — Number of X input bits `uint16_t y_size` — Number of Y output bits `uint16_t m_size` — Number of M internal bits `uint16_t d_size` — Number of D words	`void`	Sets the sizes of X, Y, M and D memory used by MC Protocol.

Example

This example uses the MPINO-16A8R8T RS-485 port Serial2, input D22, and transistor output D39.

void setup() {
  IMcMem(32, 32, 64, 64);  // Set the X·Y·M·D memory sizes used by MC Protocol.
  IMcAdr(0, 0, 0, 0);  // Set the start addresses of X·Y·M·D memory.
  IMcInit(Serial2, 1, 9600);  // Set the communication port, station number and baud rate.
}
 
void loop() {
  IMcProtocol();  // Check incoming requests and process MC Protocol responses.
  if (X != nullptr) X[0] = digitalRead(22) == HIGH;
  if (Y != nullptr) digitalWrite(39, Y[0] ? HIGH : LOW);
}

Precautions

Keep calling IMcProtocol() in loop().
Do not confuse hexadecimal addressing for X/Y with decimal addressing for M/D.
Do not use X/Y/M/D before allocating the pointers.
If Cnet or Modbus reallocates shared M/D memory at runtime, the addresses used by MC Protocol change. Complete all memory size settings in setup() and do not call them again at runtime.
Allocation functions do not return success status. For nonzero sizes, verify the corresponding global pointer is not nullptr before accessing it.

Built-in Commands in the Same Category

← Built-in Command List

ILOGICS Product Documentation

Table of Contents

IMcMem()

Commands

Example

Precautions

Built-in Commands in the Same Category