Iton() (On Delay Timer) returns true only after the condition has remained ON for a specified time.

bool Iton(uint8_t timer_id, bool state, unsigned long delayTime)

void loop() {
  bool run = digitalRead(0);
 
  if (Iton(40, run, 1000)) {
    digitalWrite(13, HIGH);
  } else {
    digitalWrite(13, LOW);
  }
}

• Timer interrupt callbacks run inside an ISR. For safety, change only flags in the callback and perform actual control processing in loop().
• Do not use slow or interrupt-dependent code such as delay(), Serial, I2C or SPI in callbacks.
• Normally, call ImodbusRTU() repeatedly in loop(). Call it from a timer interrupt with a sufficient interval only when long delay() calls or debug output slow down loop().
• Do not use the default ItimerSet() together with tone() using Timer2 or analogWrite() on Timer2 PWM pins.
• Explicitly using Timer1, Timer3, Timer4 or Timer5 may conflict with PWM, analog output or high-speed counter functions using that timer.
• Configure only one Itimer callback per hardware timer.
• Defining an ISR for the same timer directly in the sketch may conflict with Itimer operation.
• ItimerStopAll() stops only hardware interrupt timers. It does not reset PLC-style timer states such as Iton, Itof or Itmr.

← Built-in Command List