en-us_commands:reference:wdt_enable
Table of Contents
WDT_ENABLE()
WDT_ENABLE() sets the Watchdog timeout and starts it.
void WDT_ENABLE(uint8_t ms)
Commands
| Command | Arguments | Return Value | Operation |
|---|---|---|---|
WDT_ENABLE(ms) | uint8_t ms | void | Sets the Watchdog timeout and starts it. |
Example
void setup() { #if defined(__AVR_ATmega128__) WDT_ENABLE(WDT_900MS); // Set the watchdog timeout and start operation. #elif defined(__AVR_ATmega2560__) WDT_ENABLE(WDT_1S); // Set the watchdog timeout and start operation. #endif } void loop() { WDT(); // Refresh the watchdog before its timeout expires. }
Precautions
- Use time constants supported by the MCU.
- Do not set a timeout shorter than the longest normal processing time.
- Do not hide program faults by placing
WDT()where it always executes unconditionally.
Built-in Commands in the Same Category
en-us_commands/reference/wdt_enable.txt · Last modified: by 127.0.0.1