en-us_products:mpino_studio2:box_functions:counter:ctu
Table of Contents
CTU Box Function
Count Up Counter
Category: Counter Box Functions
Behavior
Increments the current value once whenever the left condition changes from OFF to ON. The done state turns ON at or above the set value, and counting stops at the maximum value.
Syntax and Arguments
Syntax: CTU C11 3
- Target — counter memory C<n> (16-bit) or DC<n> (32-bit) that stores the count value
- preset — count at which the done bit turns ON. An integer or a memory address such as
D10(time units are not accepted)
Behavior Example
| Run condition | Before | Command entered | Expected result |
|---|---|---|---|
| Left condition ON | C11=0 | CTU C11 3 | 3 rising edges → C11=3, C11 done contact=ON |
Cautions
- A counter changes once per rising edge of the left condition. On MPINO-8A4R(T)-S, C0 through C10 are mapped to board functions, so use C11 or later for a counter.
- If you enter a memory address such as
D10as the preset, you can change the target count while running, for example from an HMI. When the memory value is 0, the counter does not complete. For details, see Set the Preset from Memory.
Box Functions in the Same Category
- CTD View details — Count Down Counter
- CTUD View details — Count Up/Down Counter
en-us_products/mpino_studio2/box_functions/counter/ctu.txt · Last modified: by 127.0.0.1
